2020/12/01 - D14 1.13
  - Added support to delay power on from G3 through dedicated BIOS option
  - FW 0E
    * Support to configurable delay on Boot from G3

2020/10/07 - D14 1.12
  - Optimization in PXE Boot management
  - Full support for LVDS management
  - Setup option to configure PCIe De-Emphasis now visible again  
  - Updated AMI NVRAM module
  - Expanded UARTSerialBus Buffer size 
  - Updated Microcode
  - FW 0D
    * Removed interrupt on SUS_S4 Pin
    * Added debouncing on all power management interrupt pins
    * Corrected bug in CPU notification (Was never resetted to an idle state)
    * Corrections in IRDA notification management
    * Corrected error in Fan RPM measurement (return value was doubled)

2020/01/24 - D14 1.10

  - Updated Microcode
  - Added support to 16Gb RAM single rank
  - Enabled Legacy Serial Redirection
  - Solved issue with fTPM enabling/disabling
  - Critical Temperature threshold corrected
  - Amplifier disabled by default

2019/09/09 - D14 1.08

  - Updated Microcode
  - Updated TXE FW
  - Support to step F1 CPU
  - Added support to "M.2 peripheral" module
  - Added support to "Stereo Amplifier" module
  - Added Infrared support
  - Added support for AMISCE
  - Patch for wrong century bit management
  - Added setup option to reduce reset duration (Affect boot time)
  - PXE Legacy boot
  - Corrected bug in STM init (could prevent PTN module to be loaded in case of embedded controller error)
  - Stm8l Fw_0B
    * Enabled Infrared Support
    * Corrected bug in cpu_wake management (Power button notification didn't work correctly)


2019/04/24 - D14 1.07

  - Patch for wrong century bit management
  - Stm8l Fw_09
    * Corrected bug in PMIC management on boot


2019/01/07 - D14 1.06

  - Added new boot options (SD and eMMC)
  - Support for changing SATA Speed
  - Virtual Com are now managed from setup (For solving Linux HSUART issues with latest kernel)
  - Restore old UEFI BIOS for LAN (Correct slow boot issue and verify error!)
  - Corrected bug in Bootcounter (From G3 counter was increased by 2 units)
  - Corrected bug in ACPI thermal zone for temperatures below 0°
  - Updated TXE
  - Added RTC Wake
  - Corrected bug "USB not working in SuperSpeed Mode"
  - Disallow blank user password
  - User password now allows to access menu in "read only mode" (User boot password always disabled)
  - Correction in 4-wire fan management
  - Bios setup menu optimization
  - Added support to step E0 CPU
  - Updated SDIO drivers
  - Corrected behavior for external 4wire fan management (a wrong pwm frequency was used)
  - Stm8l Fw_08
    * Corrected bug in IAP code that could cause issues during the firmware verify phase 
    * IAP Optimizations: Corrected bug in IAP_Start() for allowing retry when an update end with failure
    * Control on boot from G3 to halt EC until CorePwrOk is high
    * Added second Power button pulse after PMIC poweron or a rail enable, after a power button pressure (board wouldn't start otherwise if chipset is in "always off mode" with CMOS battery inserted)
    * Smbus Register aligned to other flavor
    * Timer period increase to 2ms


2018/05/29 - D14 1.04

  - First Official Release

