If you have an account with us, please log in.

* Required Fields



Cross Platform Development Kit compatible with both x86 and ARM COM Express™ Type 6 modules

Additional Information

Video Interfaces 1 x LVDS (18 / 24 bit Single / dual channel) 34-pin connector
1 x Backlight Connector
1 x eDP connector
2 x combo DP / HDMI Connectors
1 x DP++ Connector
1 x VGA connector
8-pin socket for External DID EEPROM
PCI Express graphics (PEG) x 16 slot
Mass Storage 2 x SATA connectors
1 x mSATA Slot
Networking 2 x Gigabit Ethernet ports
USB 4 x USB 3.0 Host ports on Type-A sockets
2 x USB 2.0 Host ports on internal pin header
PCI-e 1 x PCI-e x4 slot, Gen2 compatible
2 x miniPCI-e slots Full / Half Size (one, combined with SIM card slot), Gen 2 compatible
Audio Internal HD Audio Codec
Triple Audio jack
S/PDIF Out 3-pin header for digital Audio
Internal pin header for audio jack/s remoting
Other Interfaces I2C EEPROM Socket
LPC Bus internal pin header
Front Panel Header
1 x 28 pin connector for additional features (I2C, ACPI signals, SMBus, Watch Dog, Thermal Management)
Internal pin header for GPIO/SD + 2 x RS-232 Serial ports (Tx/RX signals)
SIM Card slot
Tachometric FAN connector, +12VDC / +5VDC selectable
Power Supply Coin cell battery Holder for CMOS and RTC
ATX Standard power connector, 24 poles, AT configurable
+12VDC Auxiliary power connector
Operating Temperature 0° ÷ +60°C

*All carrier board components must remain within the operating temperature at any and all times, including start-up; carrier operating temperature is independent of the module installed. Please refer to the specific module for more details. Actual temperature will widely depend on application, enclosure and/or environment. Upon customer to consider specific cooling solutions for the final system.
Dimensions 170 x 170 mm (6,7” x 6,7”)

The COM Express Type 6 Cross Platform Development Kit is a complete package based on CCOMe-965, a carrier board on miniITX form factor specifically designed as a development board to explore the possibilities offered by COM Express™ Type 6 modules. The Kit contains all the necessary materials to start developing your application using any COM Express Type 6 architecture, either x86 or ARM, with the possibility of swapping from one to the other with minimal effort and time-consumption.




The Development kit contains the following material:
• CCOMe-965 carrier board
• HDMI Cable High-Speed 19p to 19p 1m
• DP Cable 1m

COM Express™ Type 6 module not included. Must be purchased separately.



P/N Description Configuration
M965-CEXDK-0000 COM Express Development Kit COM Express Type 6 Cross Platform Development Kit
Do you want to buy this product?

See also

view more

SECO S.p.A. Via Calamandrei, 91, 52100 Arezzo Italy - Phone +39 0575 26979 - Fax: +39 0575 350210 - P.IVA 00325250512
Reg. Imprese n. 4196 Arezzo - REA n. 70645 - Meccanografico AR007079

Images are for illustrative purposes only. Actual product may differ
- ©SECO 2014, All rights reserved.


Payment with major credit cards (through Paypal service)


This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. To learn more or change configurations, read our cookies policy